Causes of Steel Clamp Accidents

Steel plate clamps are commonly used lifting tools, and they should be operated with caution during operation. If the operator is negligent or the operation method is improper, it will cause the hanging objects or spreaders to fall, resulting in accidents. Accidents caused by clamps are mainly due to the following reasons:

1.Improper clamp binding method, poor operation of the staff, improper selection of spreaders and rigging, failure of lifting and overload limiters, etc. Therefore, it is necessary to pay more attention to the daily maintenance of the clamps to avoid accidents.

2.The lifting height limiter must be effective to avoid over-hoisting accidents. The operator should check whether the lifting height limiter is valid before homework, and it should not be allowed to start when it fails.

3. Pay attention to check the clamps, whether they are worn or cracked and deformed, and those that should be discarded are not allowed to be used.

4. To check the condition of the wire rope of the clamp, the wire rope must be carefully inspected from the beginning to the end before each operation, whether there is wear, broken wire, broken off, obvious deformation, kink, bending, etc., which do not meet the requirements should be replaced in time.

The technical performance of the Steel Clamp has been improved through the research and years of operation experience of Henan flag crane Co., ltd technicians. Flagcrane provides standard and non-standard cranes and spreaders that have passed third-party certification. Welcome to flagcrane's factory visit.